Linux でビデオ録画【六枚目】
ivtvの話題はここでいいですか?
kernel-2.6.28でDCT-MTVP1がうまく認識できません。
起動時は一応初期化されてるように見えますが、
----
ivtv: Start initialization, version 1.4.0
ivtv0: Initializing card #0
ivtv0: Autodetected Nagase Transgear 5000TV card (cx23416 based)
ACPI: PCI Interrupt Link [APC3] enabled at IRQ 18
ivtv 0000:04:06.0: PCI INT A -> Link[APC3] -> GSI 18 (level, low) -> IRQ 18
ivtv0: Unreasonably low latency timer, setting to 64 (was 32)
tuner 3-0043: chip found @ 0x86 (ivtv i2c driver #0)
tda9887 3-0043: creating new instance
tda9887 3-0043: tda988[5/6/7] found
All bytes are equal. It is not a TEA5767
tuner 3-0060: chip found @ 0xc0 (ivtv i2c driver #0)
saa7115 3-0021: found saa7115 while saa7114 was expected
saa7115 3-0021: saa7115 found (1f7115d0e100000) @ 0x42 (ivtv i2c driver #0)
upd64031a 3-0012: chip found @ 0x24 (ivtv i2c driver #0)
upd64083 3-005c: chip found @ 0xb8 (ivtv i2c driver #0)
tuner-simple 3-0060: creating new instance
tuner-simple 3-0060: type set to 53 (Philips FQ1286)
ivtv0: Registered device video0 for encoder MPG (4096 kB)
ivtv0: Registered device video32 for encoder YUV (2048 kB)
ivtv0: Registered device vbi0 for encoder VBI (1024 kB)
ivtv0: Registered device video24 for encoder PCM (320 kB)
ivtv0: Initialized card #0: Nagase Transgear 5000TV
ivtv: End initialization
kernel-2.6.28でDCT-MTVP1がうまく認識できません。
起動時は一応初期化されてるように見えますが、
----
ivtv: Start initialization, version 1.4.0
ivtv0: Initializing card #0
ivtv0: Autodetected Nagase Transgear 5000TV card (cx23416 based)
ACPI: PCI Interrupt Link [APC3] enabled at IRQ 18
ivtv 0000:04:06.0: PCI INT A -> Link[APC3] -> GSI 18 (level, low) -> IRQ 18
ivtv0: Unreasonably low latency timer, setting to 64 (was 32)
tuner 3-0043: chip found @ 0x86 (ivtv i2c driver #0)
tda9887 3-0043: creating new instance
tda9887 3-0043: tda988[5/6/7] found
All bytes are equal. It is not a TEA5767
tuner 3-0060: chip found @ 0xc0 (ivtv i2c driver #0)
saa7115 3-0021: found saa7115 while saa7114 was expected
saa7115 3-0021: saa7115 found (1f7115d0e100000) @ 0x42 (ivtv i2c driver #0)
upd64031a 3-0012: chip found @ 0x24 (ivtv i2c driver #0)
upd64083 3-005c: chip found @ 0xb8 (ivtv i2c driver #0)
tuner-simple 3-0060: creating new instance
tuner-simple 3-0060: type set to 53 (Philips FQ1286)
ivtv0: Registered device video0 for encoder MPG (4096 kB)
ivtv0: Registered device video32 for encoder YUV (2048 kB)
ivtv0: Registered device vbi0 for encoder VBI (1024 kB)
ivtv0: Registered device video24 for encoder PCM (320 kB)
ivtv0: Initialized card #0: Nagase Transgear 5000TV
ivtv: End initialization
|
|
|
779 ：login:Penguin：2009/03/27(金) 22:26:24 ID:hn4MDq/k
(続き)
ivtv-tuneすると次のエラー
----
ivtv0: Unable to open firmware v4l-cx2341x-enc.fw (must be 376836 bytes)
ivtv0: Did you put the firmware in the hotplug firmware directory?
ivtv0: Retry loading firmware
ivtv0: Unable to open firmware v4l-cx2341x-enc.fw (must be 376836 bytes)
ivtv0: Did you put the firmware in the hotplug firmware directory?
ivtv0: Failed to initialize on minor 0
ivtv0: Failed to initialize on minor 0
ivtv0: Failed to initialize on minor 0
ivtv0: Failed to initialize on minor 0
ファームウェアは/lib/firmware/に置いています。
2.6.25ではこれでうまく動いていました。
たぶんudev,dbus,haldの辺りが変わったからだと思うのですが。。。
ivtv-tuneすると次のエラー
----
ivtv0: Unable to open firmware v4l-cx2341x-enc.fw (must be 376836 bytes)
ivtv0: Did you put the firmware in the hotplug firmware directory?
ivtv0: Retry loading firmware
ivtv0: Unable to open firmware v4l-cx2341x-enc.fw (must be 376836 bytes)
ivtv0: Did you put the firmware in the hotplug firmware directory?
ivtv0: Failed to initialize on minor 0
ivtv0: Failed to initialize on minor 0
ivtv0: Failed to initialize on minor 0
ivtv0: Failed to initialize on minor 0
ファームウェアは/lib/firmware/に置いています。
2.6.25ではこれでうまく動いていました。
たぶんudev,dbus,haldの辺りが変わったからだと思うのですが。。。
780 ：login:Penguin：2009/03/27(金) 23:06:45 ID:y9ZPDjKH
781 ：login:Penguin：2009/03/28(土) 00:38:14 ID:OUa+WSsc
サイズは一致してるのですが古いのでしょうか
gentooでmedia-tv/ivtv-firmwareのパッケージで入れてます
$ ls -l /lib/firmware/v4l-cx2341x-enc.fw
-rw-r--r-- 1 root root 376836 2007-09-18 00:36 /lib/firmware/v4l-cx2341x-enc.fw
gentooでmedia-tv/ivtv-firmwareのパッケージで入れてます
$ ls -l /lib/firmware/v4l-cx2341x-enc.fw
-rw-r--r-- 1 root root 376836 2007-09-18 00:36 /lib/firmware/v4l-cx2341x-enc.fw
782 ：login:Penguin：2009/03/28(土) 12:08:32 ID:3Nn/uJ4i
gentooの設定はしらんが、
ホットプラグ経由でファイル見にいけていないんじゃない？
ファイルを別な名前にしても同じ現象が起きると思う
ホットプラグ経由でファイル見にいけていないんじゃない？
ファイルを別な名前にしても同じ現象が起きると思う